Book Light Battery

The lithium battery lasts up to 3 years without needing to be replaced, unfortunately the technology is not available so that the batteries do not die, we hope that one day this technological advance will be possible; although it is most likely to be hidden by large corporations just as it happened with incandescent bulbs that never get damaged.

With the Ecologic Mart Book Lights we do not have a better battery to include, but at least we can offer the possibility of it being replaced easily, then you can follow step by step instructions on how to replace the battery.

Procedure when the battery connector is compatible with the receiver in the base of the book light.

1. Using a Phillips screwdriver, remove the 4 screws from the base of the lamp.

2. Carefully separate the two parts without pulling too hard to avoid breaking a cable.

 

3. Locate the connector that connects the battery to the integrated circuit, with the right hand holding the connector pulls to separate it from the female.

4. Remove the battery from its place by prying on one side with the screwdriver.

5.  Insert the male connector with the guide down and the pins facing up (there is only one way to do it due to the guide that has the connector)

 

 

6. Place the new battery in the place of the previous one and join the two parts of the base taking care that the cable does not come out the sides and install the screws.

Procedure when the battery connector is NOT compatible with the receiver or there is no connector (welded cables) at the base of the book light.

1. Using a Phillips screwdriver, remove the 4 screws from the base of the lamp.

2. Carefully separate the two parts without pulling too hard to avoid breaking a cable.

Book light without battery connector

 

3. Cut the cables as close as possible to the OLD battery.

4. Remove the battery from its place by prying on one side with the screwdriver.

5. Remove the connector of the new battery (if any) by cutting the cables as close as possible to the connector.

5.  Peel 1cm (1/2 in) from the tip of each wire.

6. Connect the red wires and insulate with electrical tape. (Optionally you can use solder to join the cables)

7. Connect the black wires and insulate with electrical tape. (Optionally you can use solder to join the cables)

8. Place the new battery in the place of the previous one and join the two parts of the base taking care that the cable does not come out the sides and install the screws.

 

NEED A SPARE BATTERY for your book light?

523450 Battery with PH 2.0mm connector type.